About this role As Board power Developer, aiming to figure out Board power solution and design for radio products, Baseband products and network router products. DCDC power solution design, including lightning protection, polarity protection, hot-swap, EMC filter, power stage and control loop design. What will you do • Board power solution and design for radio products, Baseband products and network router products. • DCDC power solution design, including lightning protection, polarity protection, hot-swap, EMC filter, power stage and control loop design. • Circuit simulation, power loss calculation and margin analysis. • Isolated and non-isolated DCDC design, task force driving, performance improvement and verification. • Schematic design, and Layout Design (guiding PCB engineer to do Placement and Routing). • Document preparation, Sch, layout, margin analysis, signal plan, verification plan/report. • Released products maintenance and root cause analysis You will bring • Master or above in Electronic Engineering, Electrical Engineering, or Automation Major. • Familiar with at least one of below converters：BUCK, BOOST, BUCK/BOOST, FLYBACK, Forward, Half-bridge, Full-bridge. • Good communication and proactive attitude to corporate with other function teams (HW, Digital, Mechanics, thermal, SW design teams) • On-hand skill in using lab equipment: DC source, Oscilloscope, Electrical load, LISN, Loop analyzer, etc. • Priority considered if experienced on Electronics components reliability control and failure analysis • Priority considered if knowledgeable on Semiconductor packaging technology and process • “Can-do” attitude for challenges and technical problems. • Collaborate effectively within a cross-functional team.